亚洲1卡二卡3卡4卡新区在线,一本色道久久综合亚洲精品蜜桃冫 ,日韩中文字幕免费视频,人妻丰满熟妇av无码区免蜜臀 ,午夜视频一区黄色视频免费,亚洲人妻丰腴AV在线,色老头亚洲秋爽AV影院

Five major reasons for the failure of CNC lathe chip removal equipment
During the operation of the CNC lathe, since the tool needs to perform cutting operations, metal debris will be generated. These debris are usually collected and recycled by the special chip removal equipment of the CNC lathe. Once the chip removal equipment has problems and cannot be cleaned in time, it will cause the lathe itself to increase its precision error. Today, our CNC lathe manufacturer will explain to you the five major reasons for the failure of the chip removal equipment of the CNC lathe.
First of all, you must know that the reasons that affect the amount of chip removal are the speed and the scraper spacing. In daily use, the working frequency of the chip removal machine is very high. If a CNC lathe actively trips, it is mostly caused by a short circuit. First, observe whether the external power supply meets the requirements of the machine tool, whether it is out of tolerance, and whether it is relatively stable. Secondly, observe whether the power switch of the lathe is damaged. If damaged, please replace it in time. Then, see if the lathe is equipped with some external equipment, such as conveyor belts, fire extinguishers, work lights, etc., whether it is connected to the wrong position or other reasons.
If the above three reasons are not found through inspection, then the wiring problem of the lathe should be considered. Generally speaking, most CNC lathes have many induction lines, so check whether the induction lines are cut off. In order to effectively reduce the failure rate of the equipment in use, the following requirements should be noted during the specific operation process:
1. Before the CNC lathe is powered on, first check whether the lubricating oil balance of the reducer is lower than the standard oil level line. If it is lower than the standard oil level line, add the corresponding total loss system oil to the marked oil level line.
2. After the engine is started, check whether the rotation direction of the sprocket is consistent with the direction indicated by the arrow on the machine logo. If not, correct it immediately.
3. The sprocket of the chip removal device of the CNC lathe is equipped with an overload safety clutch, and the chip removal machine has been adjusted during factory commissioning.
4. After starting, if the friction plate of the CNC lathe is found to slip, it should be stopped immediately to check whether there is any foreign matter stuck on the chain belt or other reasons.
5. Regularly check whether the clamping force of the friction plate of the chip conveyor meets the requirements and check whether the compression amount of the disc spring is within the specified value range.
The above are the five major reasons for the failure of CNC lathe chip removal equipment, which have been compiled and released by our CNC lathe manufacturer Haisu Machinery. We hope that the above explanation can be of some help to you when using CNC lathe chip removal equipment in the future.