亚洲1卡二卡3卡4卡新区在线,一本色道久久综合亚洲精品蜜桃冫 ,日韩中文字幕免费视频,人妻丰满熟妇av无码区免蜜臀 ,午夜视频一区黄色视频免费,亚洲人妻丰腴AV在线,色老头亚洲秋爽AV影院

What are the conditions for the installation of small CNC lathes in the workshop?
1, temperature conditions
The temperature of the CNC machining center is less than 30 degrees and the relative temperature is less than 80%. In general, CNC control box is equipped with internal fan or chillers to keep electronic components, especially the central processor operating temperature is constant or the temperature difference is very small. Excessive temperature and humidity will cause the control system components to be reduced in life and lead to increased failures. Increased temperature and humidity, increased dust will cause bonding on the integrated circuit board and lead to short circuit.
2, the processing center location environmental requirements
The location of the machining center should be kept away from the vibration source and should avoid the effects of direct sunlight and heat radiation and avoid the effects of moisture and airflow. Such as CNC machine tools near the vibration source, the processing center should be set around the anti-trench. Otherwise it will directly affect the processing accuracy and stability of CNC machine tools, electronic components will make poor contact, failure, affecting the reliability of the processing center.
3, power requirements
General processing center installed in the machine shop, not only the ambient temperature changes, the use of poor conditions, and a variety of mechanical and electrical equipment, resulting in large fluctuations in the grid. Therefore, the installation of the center of the processing center, the need for strict control of the power supply voltage. The supply voltage fluctuation must be within the allowable range and remain relatively stable. Otherwise it will affect the processing center CNC system of normal work.
4, according to the provisions of the manual processing center
When the user is using the machining center, it is not permissible to change the parameters set by the manufacturer in the control system. The parameters of these machining centers are directly related to the dynamic characteristics of the components of the machining center. Only the gap compensation parameter values can be adjusted according to the actual situation.

http://www.topsandiegoagent.com/